With the door handle off it opened and closed just fine.
Outside door handle won t open.
Texases july 6 2016 5 49am 3 when this happened to me it was a broken plastic connector at the door handle.
The repair is a complete door handle replacement.
Now if the door is initially locked and i go to unlock it with either the fob.
A door knob or door handle uses a spring loaded latch.
Initially only the outside door handle would not open the latch door but the inside worked just fine.
In the resting state of the lock the spring is extended.
Some vehicle have updated parts where the stress point of the handle is now metal.
I recently replaced the driver side front door latch and handle cables in a 09 cc.
The turning of the handle retracts the latch by pulling on the spring and compressing it.
Jun 11 2015 if you are having trouble because your truck door won t open from the inside or outside there is most likely an issue with rods that hold the lock in place.
Open the door and close slowly to see if it s dragging some place.
Door opens fine from outside.
This is all to say that when your door knob turns but won t open the issue is with you handle not properly interacting with the spring in the latch.
Could be as simple as loose screws in the hinges lack of the longer supplied when the door was new that are long enough to reach the framing.
An exterior door that refuses to open can be caused by several things from swollen or warped wooden door and frames or old neglected hardware.
Look for the set screw on neck of the knob between the handle and door.
When the door knob is locked the handle will not turn which keeps the latch from retracting.
The outside handle feels loose like if there was cable attached to it it slipped out.
The rods are inserted into the door handle which is made of plastic.
It may be on the.
The plastic tab that this metal rod goes into on the back of the door handle mechanism probably broke off the back.
This is a high use item on the vehicle and is made from cheap thin plastic.
There should be about the width of a nickel clearance from the door to the jamb.
If the bolt moves but not enough to allow the door to open the mechanism probably needs lubrication.
The only way to tell what s wrong is to remove the inner door panel it should be obvious famous last words.
Once you have identified the problem finding and implementing a solution is fairly simple.
Over time the plastic part of the door handle where the rod is located breaks.
There is a thin metal rod that runs from the door latch to the back of the door handle mechanism.
There s two different connecting rods tom the lock one from the inside handle and one from the outside.